Further Insight into the Photostability of the Pyrene Fluorophore in Halogenated Solvents

Pyrene fluorophores of pyrene‐functionalized CdSe quantum dots (QD@Py), as well as alkylpyrene and pyrene itself (Py), undergo fast degradation in aerated chloroform under ultraviolet‐A (UV‐A, 316<λ<400 nm) illumination. Steady‐state fluorescence studies of irradiated chloroform solutions of QD@Py show formation of new bands, red‐shifted compared to that of the pyrene moiety. Similar behaviour is observed for pyrene and the alkylpyrene system. Column chromatography of the pyrene photolysate in chloroform allowed us to isolate photoproducts arising from pyrene degradation, and to obtain information on the structure of the photoproducts responsible for the emission bands. The most predominant photoproducts were those originating from the reaction of pyrene with dichloromethyl radicals. The phototransformation of QD@Py and the alkylpyrene involves mainly detachment of the alkyl chain from the aromatic ring, induced also by dichloromethyl radicals, and oxidation of the alkyl chain at the benzylic position was detected as well. By contrast, these pyrene systems show a high photostability in aerated dichloromethane. Transient absorption measurements showed formation of both pyrene triplet and pyrene radical cation for all pyrene systems in these halogenated solvents. The yield of pyrene radical cations for Py is higher than for QD@Py and the alkylpyrene. In addition, pyrene radical cations were longer‐lived in dichloromethane than in chloroform. The reason for the pyrene photostability in dichloromethane is the different reactivity of chloromethyl and dichloromethyl radicals towards pyrene and oxygen. These studies show that the use of dichloromethane can be a suitable alternative to chloroform when the good solubility properties of these halogenated solvents are needed to dissolve pyrene when this chromophore is used as a fluorescent probe.     

Comparative study of the in vitro bioactivities of Bupleurum rigidum and B. fruticescens

Decoctions of the aerial parts of either Bupleurum rigidum or B. fruticescens are equally used in certain parts of Spain for the treatment of topical and musculoskeletal inflammations. In the present paper, their phytochemical profile and pharmacological value has been compared. After chromatographic and spectral analyses we could establish the presence of rutin and absence of chlorogenic acid in B. fruticescens, whilst the contrary applies to B. rigidum, providing a means to chemically differentiate extracts and dry materials from the two species. Their free radical scavenging and antiperoxidative activities were similar, with B. fruticescens being more active overall. The infusions of both Bupleurum species also showed similar anti-inflammatory activity when tested by NF-kappaB assay (40% and 42% at 60 microg x mL(-1)), as well as in a hexosaminidase exocytosis assay (30% at 50 microg x mL(-1)). Antimigratory effects on rat melanoma B16F10 showed significant activity for both infusions, with B. rigidum twice as potent as B. fruticescens, the activity of the latter not being fully explained by its content of rutin. Taking all these results together, we can conclude that, in the selected experimental models, there exist an in vitro bioequivalence of the infusions from both species, which is in agreement with the majority of ethnopharmacological reports.     

Study of magnetic and structural properties of ferrofluids based on cobalt-zinc ferrite nanoparticles

Ferrofluids are colloidal systems composed of a single domain of magnetic nanoparticles with a mean diameter around 30 nm, dispersed in a liquid carrier. Magnetic Co_(1−x)Zn_xFe₂O₄ (x=0.25, 0.50, 0.75) ferrite nanoparticles were prepared via co-precipitation method from aqueous salt solutions in an alkaline medium. The composition and structure of the samples were characterized through Energy Dispersive X-ray Spectroscopy and X-ray diffraction, respectively. Transmission Electron Microscopy (TEM) studies permitted determining nanoparticle size; grain size of nanoparticle conglomerates was established via Atomic Force Microscopy. The magnetic behavior of ferrofluids was characterized by Vibrating Sample Magnetometer (VSM); and finally, a magnetic force microscope was used to visualize the magnetic domains of Co_(1−x)Zn_xFe₂O₄ nanoparticles. X-ray diffraction patterns of Co_(1−x)Zn_xFe₂O₄ show the presence of the most intense peak corresponding to the (311) crystallographic orientation of the spinel phase of CoFe₂O₄. Fourier Transform Infrared Spectroscopy confirmed the presence of the bonds associated to the spinel structures; particularly for ferrites. The mean size of the crystallite of nanoparticles determined from the full-width at half maximum of the strongest reflection of the (311) peak by using the Scherrer approximation diminished from (9.5±0.3) nm to (5.4±0.2) nm when the Zn concentration increases from 0.21 to 0.75. The size of the Co-Zn ferrite nanoparticles obtained by TEM is in good agreement with the crystallite size calculated from X-ray diffraction patterns, using Scherer's formula. The magnetic properties investigated with the aid of a VSM at room temperature presented super-paramagnetic behavior, determined by the shape of the hysteresis loop. In this study, we established that the coercive field of Co_(1−x)Zn_xFe₂O₄ magnetic nanoparticles, the crystal and nanoparticle sizes determined by X-ray Diffraction and TEM, respectively, decrease with the increase of the Zn at%. Finally, our magnetic nanoparticles are not very hard magnetic materials given that the hysteresis loop is small and for this reason Co_(1−x)Zn_xFe₂O₄ nanoparticles are considered as soft magnetic material.     

DFT studies on cobalt-catalyzed cyclotrimerization reactions: the mechanism and origin of reaction improvement under microwave irradiation

A DFT computational mechanistic study of the [2+2+2] cyclotrimerization of a diyne with benzonitrile, catalyzed by a cobalt complex, has been carried out. Three alternative catalytic cycles have been examined together with the precatalytic step (responsible for the induction period). The favored mechanism takes place by means of an intramolecular metal-assisted [4+2] cycloaddition. The beneficial role of microwave activation has been studied. It is concluded that microwave irradiation can decrease the catalytic induction period through thermal effects and can also increase the triplet lifetime and promote the reaction, thus improving the final yield.     

Synthesis and functionalization of new polyhalogenated BODIPY dyes. Study of their photophysical properties and singlet oxygen generation

A theoretical and experimental study on the iodination of BODIPY dyes with different degrees of substitution has been developed. Polyhalogenated BODIPYs synthesized in this work are the first examples of this type of dyes with more than two halogen atoms in the BODIPY core and they can be selectively functionalized. Surprisingly, the position in which halogen is attached has a marked effect in the photophysical properties and modulates the fluorescence capacity of the resulting BODIPY. These iodinated BODIPYs are efficient singlet oxygen generators.     

Synthesis of functionalized cyclic enamines from lithium alkylphenyl sulfones and N‐carbo‐tert‐butoxy lactams

Alkylphenyl sulfones 3 are appropriate synthons for the synthesis of 2‐phenylsulfonyl alkylidene pyrro‐lidine or piperidine derivatives 1 in good to moderate yields. The lithium alkyl sulfones 4 are first reacted with the desired protected lactams and then subjected to acidic methanolysis to afford the unusual enam‐ines 1a‐e . NMR studies (COSY ¹H‐¹H, COSY ¹H‐¹³C, NOE) showed the Z enamines to exist in a dynamic equilibrium with the corresponding imines 2 . The stereochemistry of the described compounds was confirmed by molecular calculations.     

Phenylsulfonyl-methylenation of aldonolactones

The low temperature addition of dilithiomethylphenyl sulfone to 2,3-O-isopropylidene-D-erythronolactone, and to 5-O-(tert-butyldimethylsilyl)-2,3-O-isopropylidene-D-ribofuranolactone gives the lactols 2 and 3a , respectively. Dehydration of lactol 2 in the presence of boron trifluoride etherate produces tetrahydrofuranylidene sulfones 5 and 6 in good yields. The reaction of lactol 3a under the same reaction conditions proceeds with formation of the 1′,5′-anhydro derivative 7 via competing intramolecular substitution.     

Extended Alkenyl and Alkynyl Benzotriazoles with Enhanced Two-Photon Absorption Properties as a Promising Alternative to Benzothiadiazoles

A series of donor–π–acceptor–π–donor (D -π-A-π-D) benzoazole dyes with 2H-benzo[d][1,2,3]triazole or BTD cores have been prepared and their photophysical properties characterized. The properties of these compounds display remarkable differences, mainly as a result of the electron-donor substituent. Dyes with the best properties have visible-light absorption over λ=400 nm, large Stokes shifts in the range of about 3500–6400 cm⁻¹, and good fluorescence emission with quantum yields of up to 0.78. The two-photon absorption properties were also studied to establish the relationship between structure and properties in the different compounds synthesized. These results provided cross sections of up to 1500 GM, with a predominance of S₂←S₀ transitions and a high charge-transfer character. Time-dependent DFT calculations supported the experimental results.